Special Design for Distribution Box - Waterproof Cable Resin Kit – Waxun

 Product Introduction

1. To joint the cables with Opposite nozzle or other method, Insulation treatment of phase line in case of the short circuit

2. With the size of cable outer diameter, the marks at each ends should be cut off for the Subsequent installation

3. Bind the sponge strip around the each end of the cable.  The specific part is the same as the access point of the two ends.

Lock the junction box and make sure each clips is fastened.

Bind the ends of the junction box with the 20# opp bag to avoid resin leakage.

4. Make the resin according to Resin instruction, fill the resin in the box untill the resin curing and cover the lid. Installation is complete.

Appendix: Instructions for use of edge waterproof sealant

Instruction of resin. (Please Strictly abide by the instruction, We are not responsible for all consequences caused by violating the following operation methods)

1. First open the spacer between component A and component B resin,mixing it well 2 to 3min .
2. Pour the mixed resin into the branch box Immediately. The resin will cure if not.
3.  The resins avoid contact with skins and eyes