Massive Selection for Hanging Cable Wedge Insulated Tension Clamp - Wedge Connector Crimp tools – Waxun

TYPE & SPECIFICATIONS

USe for installing JXL series wedge Connector : JXL1, JXL-2. JXL-3,JXL-4,

JXL-small  for JXL-1,XL-2 “C”sharp wedge connector

JXL-big for JXL-3,JXL-4 “C”sharp wedge connector

ESTRUCTURAA

1. fixed handle     2. Free handle       3 .Cylinder body           4.Oil Pump
5.Pivot Screw     6.Unloading Device   7.Clamping head      8.Pision

DIRECTIONS

1.According to the connector “C” of the body of the wedge point the type of tools.

JXL-1, JXL-2 must use JXL-small;JXL3, JXL-4 must use JXL-big

2.Move the brush oxide layer on the bare conductor, if the conductor is insulated, you must strip the insulation coating.

3.Put Conductor on ‘C’ Sharp.then  putinside the wedge inner parts.  till the wedge inner parts marking line covered by “C’ body. if not tight enought. you can use hammer to put wedge inner part more tight. (if use hammer . should not use strong power) then put wedge connector and conductor into the tools. position see pic-l.

4. Press free handle to make the wedge connector  full tight. full tight mean the “C” body edge on same level with wedge inner parts.see pic-2.

5.After full adjustment device download turn counterclockwise. then the piston returns to its start state.