Factory Supply Wedge Type Dead End Clamp - Ampact clamp installation tool – Waxun
Factory Supply Wedge Type Dead End Clamp - Ampact clamp installation tool – Waxun Detail:
Installation Steps
1. Insert the conductor and the wedge end into the groove until to the marking line.
2. Put The clamp on the gun seat and locate it, with wire thread insert. Make sure the end of the gun tightly top the wedge.
3. Remove the back cover of the gun and load the bullet core. Then install the back cover and tighten it.
4. Pull the rear cable to the right place and press the button. Bullet core firing,The push rod will push the wedge core into the
inner of the clamp
5. Remove the ejection gun and unscrew the rear cover, taking the bullet core out. Clean the inner and outer suface of the
tools, with prevention oil and put in the tool case.
Product detail pictures:
Related Product Guide:
We are also specializing in improving the things management and QC method in order that we could retain terrific edge inside the fiercely-competitive small business for Factory Supply Wedge Type Dead End Clamp - Ampact clamp installation tool – Waxun, The product will supply to all over the world, such as: Romania, Rotterdam, Israel, Our company abides by the management idea of "keep innovation, pursue excellence". On the basis of assuring the advantages of existing merchandise, we continuously strengthen and extend product development. Our company insists on innovation to promote the sustainable development of enterprise, and make us become the domestic high-quality suppliers.
By Delia from Finland - 2017.03.28 16:34
The sales manager is very patient, we communicated about three days before we decided to cooperate, finally, we are very satisfied with this cooperation!
By Ruby from Istanbul - 2017.11.12 12:31
