Factory Cheap Hot Dead End Wedge Type Insulation Strain Clamp - Ampact clamp installation tool – Waxun
Factory Cheap Hot Dead End Wedge Type Insulation Strain Clamp - Ampact clamp installation tool – Waxun Detail:
Installation Steps
1. Insert the conductor and the wedge end into the groove until to the marking line.
2. Put The clamp on the gun seat and locate it, with wire thread insert. Make sure the end of the gun tightly top the wedge.
3. Remove the back cover of the gun and load the bullet core. Then install the back cover and tighten it.
4. Pull the rear cable to the right place and press the button. Bullet core firing,The push rod will push the wedge core into the
inner of the clamp
5. Remove the ejection gun and unscrew the rear cover, taking the bullet core out. Clean the inner and outer suface of the
tools, with prevention oil and put in the tool case.
Product detail pictures:
Related Product Guide:
The corporation keeps to the operation concept "scientific management, superior quality and performance primacy, consumer supreme for Factory Cheap Hot Dead End Wedge Type Insulation Strain Clamp - Ampact clamp installation tool – Waxun, The product will supply to all over the world, such as: Oman, Georgia, Melbourne, Our company offers the full range from pre-sales to after-sales service, from product development to audit the use of maintenance, based on strong technical strength, superior product performance, reasonable prices and perfect service, we will continue to develop, to provide the high-quality products and services, and promote lasting cooperation with our customers, common development and create a better future.
By Odelette from Malta - 2018.02.12 14:52
The factory can meet continuously developing economic and market needs, so that their products are widely recognized and trusted, and that's why we chose this company.
By Kimberley from Colombia - 2018.11.02 11:11
