Wedge Connector Crimp tools
Type & Specifications
● USe for installing JXL series wedge Connector : JXL1, JXL-2. JXL-3,JXL-4,
● JXL-small for JXL-1,XL-2 “C”sharp wedge connector
● JXL-big for JXL-3,JXL-4 “C”sharp wedge connector
Estructuraa
1. fixed handle 2. Free handle 3 .Cylinder body 4.Oil Pump
5.Pivot Screw 6.Unloading Device 7.Clamping head 8.Pision
Directions
1. Insert the conductor and the wedge end into the groove until to the marking line.
2. Put The clamp on the gun seat and locate it, with wire thread insert. Make sure the end of the gun tightly top the wedge.
3. Remove the back cover of the gun and load the bullet core. Then install the back cover and tighten it.
4. Pull the rear cable to the right place and press the button. Bullet core firing,The push rod will push the wedge core into the inner of the clamp
5. Remove the ejection gun and unscrew the rear cover, taking the bullet core out. Clean the inner and outer suface of the tools, with prevention oil and put in the tool case.
